Daily Use; Ignition Of The Burner - AEG HG694840NB Benutzerinformation

Symbol

5. DAILY USE

WARNING!
Refer to Safety chapters.
5.1 Burner overview
A. Flame spreader
B. Ignition candle
C. Thermocouple

5.2 Ignition of the burner

Always light the burner
before you put on the
cookware.
WARNING!
Do not light the burner when
the flame spreader is
removed.
WARNING!
Be very careful when you use
open fire in the kitchen
environment. The
manufacturer declines any
responsibility in case of the
flame misuse.
Description
minimum gas supply
1. Push the control knob down and turn
it counterclockwise to the maximum
gas supply position (
2. Keep the control knob pushed for
equal or less than 10 seconds. This
lets the thermocouple warm up. If
not, the gas supply is interrupted.
3. Adjust the flame after it is regular.
If after some tries the burner
A
does not light, check if the
flame spreader is in correct
position.
WARNING!
B
Do not keep the control
knob pushed for more than
15 seconds. If the burner
C
does not light after 15
seconds, release the control
knob, turn it into off position
and try to light the burner
again after minimum 1
minute.
CAUTION!
In the absence of electricity
you can ignite the burner
without electrical device; in
this case approach the
burner with a flame, turn the
control knob counter-
clockwise to maximum gas
supply position and push it
down. Keep the control
knob pushed for equal or
less than 10 seconds to let
the thermocouple warm up.
If the burner accidentally
goes out, turn the control
knob to the off position and
try to light the burner again
after minimum 1 minute.
ENGLISH 11
).