Programs Customisation - kbs TS 801 Betriebs- Und Installationsanweisung

At any time it is possible to modify the time, phases, temperature, relative humidity and recirculation values. The
modi fi cations will have immediate effect after programming or by not operating for 15 seconds.
The fresh air fan can also be activated or deactivated manually by pressing the key
I f the fan is active, a point appears on the display after Ri.
7.3.6b PROGRAMS CUSTOMI SATI ON
I t is possible to create customised program to satisfy the various seasoning requirements.
Customisation consists in creating the correct temperature, relative humidity and fresh air conditions in 6 programmable
spaces of time.
The spaces of time correspond to phases (f1 - f2 - f3 - f4 - f5 - f6).
To insert the desired values in every phase, proceed as follows:
MENU
By pressing the key for a prolonged period, the
of the program in progress will appear on the left display.
Use the keys to scroll the program numbers. On reaching that desired, to
or
fi
be modi ed, press the
fl
( ashing). By pressing
the values of the set of the pre-selected program.
ENTER
By pressing the temperature "t °C" is displayed (
are operating and with the
passing automatically to the successive display: of the relative humidity (Rh % -
To increase or decrease the set, act on the
value.
ENTER
fi
Press to con rm and pass to the next value to modify.
The display shows the duration value of the phase (
OFF appears. Using the
ENTER
Press to con fi rm the duration of the phase and pass automatically to set fresh air in
fl
the cell (Ri % - ashing).
To modify the setting of the % value, act on the
ENTER
fi
Press to con rm and pass to the following screen corresponding to the phase "f1"
fl
( ashing). With the
are regulated by operating as previously described for "f1".
On completion of insertion of the data, press the
The phases in which a value equal to 0 will be skipped (the display shows'OFF').
NOTE
: By setting the duration of the phase at maximum value (599 d) the period results
fi
set at in nite "I NF". Every successive phase set will no longer be performed.
ENTER
fi
key to con rm the selection: pass automatically to phase 'f1'
increase or decrease the number of the phase to modify
or
key modify the value.
or
key it is possible to set up to 96 hours with "h" and days with "d".
key increase to value to "f2". From this phase, up to n°6, the values
ENTER
for a prolonged period.
fl
ashing letter P ... followed by the number
fl
ashing) of the phase in which you
ENTER
is used to memorise it,
keys again until reaching the desired
or
fl
ashing). I n the programs not yet used
keys.
or
MENU
key to memorise the cycle selected.
EN - 23
fl
ashing).