Installation Instructions - Thermalright TRUE Spirit 120 Direct Bedienungsanleitung

Installation Instructions:

Step 1:
Step1 : Rubber Tubes Installation
Insert the four black Rubber Tubes (Noise damping use) into the four indents on the front of the heat-sink
body. Do not remove them.
Step 2:
Step 2 : Backplate Installation
Choose the platform (775/1150/1151/1155/1156/1366) you are in use. Make four M3L10 Screw Pillars
go through the Metal Back Plate and the Mylar film from bottom towards top.And then place the Metal
Back Plate on the table. Put the four Washers (for Intel) around the Screw Pillars.
Step 3:
Step 3 : 775 Back Plate Cap
Note: When installing on a 775 platform, please
first insert the Back Plate Cap into the opening on
the Back plate, make sure you have the Cap facing
downwards. (Only for LGA775 platform, all other
platforms go directly to Step 4.).
3
1366
775
Step 4:
1
Step 4 : Screw Cylinder Installation
Place the motherboard on top of the Back Plate.
See the four Screw Pillars go through the four holes
around the processor socket.Cap the four Screw
Pillars with the four Screw Nuts.Make sure the side
with a washer is facing the Back Plate.
1150
1151
1155
1156
4
2
3