Herunterladen Inhalt Inhalt Diese Seite drucken

Marmitek GIGAVIDEO800 HDMI Gebrauchsanleitung Seite 5

Wireless hd audio/video sender
Inhaltsverzeichnis

Werbung

Verfügbare Sprachen
  • DE

Verfügbare Sprachen

  • DEUTSCH, seite 9
USING THE GIGAVIDEO 800 SET
1. Place the two AAA batteries into the remote control.
2. Press the Power button of the GV800 Transmitter & Receiver to switch it ON. During warm-up the Power LED will
blink blue until the signal link between the Transmitter & Receiver is established.
3. Switch ON the HDTV or HD projector (to HDMI mode) and the HD device you want to view.
4. Press the Source 1 HDMI, 2 HDMI, 3 YPbPr or 4 YPbPr button, until you see the video from your device.
Note:
x
If all operation is normal, the Power LED will glow solid blue and Signal Strength will light in blue with max. 3
LEDs to visualise the signal strength (refer to LED details for more information).
x
Make sure your HD Devices are powered (ON).
x
Switching time between two source could be approximately 15 ~ 20 seconds.
x
If video from YPbPr component source device appears but dim, than press the 3 or 4 YPbPr button repeatedly on
the remote to fine-tune picture performance.
© MARMITEK
5

Werbung

Inhaltsverzeichnis
loading

Inhaltsverzeichnis