SWM SILVER VASE Handbuch - Gebrauch - Wartung Seite 142

- Slide the turning indicator cables, securing them
to the frame with straps and reconnect the rel-
evant connectors (9).
9
- Reconnect the rear light connector (3) and the
plate light connector (4), matching the colours:
• Green wire connected with yellow wire.
• Black wire connected with brown wire.
3
EN - 68
- Assemble the seat (2) with the tail section (7) on
the bike, fitting it into the front slot, taking care to
position the wiring so that it is not crushed when
the seat is lowered.
- Secure the seat by screwing in the two nuts (1).
4
REMOVING THE PASSENGER FOOT BOARDS
The following procedure is to remove the right pas-
senger foot board, operate in the same way for the
left foot board.
- Undo the screws (1) and (2) and remove the foot
board (3).
- Retrieve the screw (1) and screw it securing the
7
silencer support (4).
2
25 Nm, 2,5 kgm, 18,42 ft/lb tightening torque.
1
3 1
2
1
4