Electrolux WTSL 4 E200 Benutzerinformation Seite 21

9.7 Starting a programme
without the delay start
Press button Start/Pause - Départ/Pause
to start the programme.
The relevant indicator stops to flash and
stays on.
On the display the indicator of the phase is
operation starts to flash.
The programme starts, the door is locked.
The display show the indicator
The drain pump can operate
for a short time when the
appliance fills water.
9.8 Behaviour of the appliance
After approximately 15
minutes from the start of the
programme:
• The appliance adjusts
automatically the cycle
time to the laundry you
have put in the drum to
have perfect washing
results in the minimum
necessary time.
• The display shows the
new time value.
9.9 Starting a programme with
the delay start
1. Press button Zeitvorwahl - Départ
Différé again and again until the
display shows the number of minutes
or hours of delay.
The related indicator comes on.
2. Press button Start/Pause - Départ/
Pause.
The appliance starts the countdown of the
delay start.
When the countdown is completed, the
programme starts automatically.
Before you press button
Start/Pause - Départ/Pause
to start the appliance, you
can cancel or change the set
of the delay start.
9.10 Cancelling the delay start
To cancel the delay start:
1. Press button Start/Pause - Départ/
Pause to set the appliance to pause.
The related indicator flashes.
2. Press button Zeitvorwahl - Départ
Différé repeatedly until the display
shows .
3. Press button Start/Pause - Départ/
Pause again to start the programme
immediately.
.
9.11 Interrupting a programme
and changing a function
You can change only some options before
they operate.
1. Press button Start/Pause - Départ/
Pause.
The related indicator flashes.
2. Change the function set.
3. Press the button Start/Pause -
Départ/Pause again.
The programme continues.
9.12 Cancelling a running
programme
1. Press button Ein/Aus - Marche/Arrêt
to cancel the programme and to
deactivate the appliance.
2. Press button Ein/Aus - Marche/Arrêt
again to activate the appliance.
Now, you can set a new washing
programme.
9.13 Opening the door
While a programme or the delay start
operates, the appliance door is locked.
1. Press button Start/Pause - Départ/
Pause.
Before starting the new
programme the appliance
could drain the water. In this
case, make sure that the
detergent is still in the
detergent compartment, if
not fill the detergent again.
If the temperature and level of
the water in the drum are too
high and the drum still rotates
you cannot open the door.
ENGLISH 21