Olympia CC 415.4 Bedienungsanleitung Seite 17

ATTENTION!
• Risk of property damage through material jam!
Pay attention to the maximum capacity of the paper infeed
(refer to Technical Data).
In the event of a material jam, the device stops and the
flashes red until the material has been removed from the infeed (refer to
Reverse Running and Clearing Residual Material).
Forward Running
The cutting mechanism runs forwards for a few seconds and shreds the material
fed in.
• Press the FWD button.
Reverse Running
Reverse operation is necessary to clear material which jams. The
flashes red in the event of a material jam.
1. Press the REV button and keep it pressed.
2. The cutting mechanism runs in reverse continuously and the (jammed) material
is released.
CAUTION!
• Risk of injury through the sharp edges of the cutting mechanism!
Never reach into the cutting mechanism.
Keep fingers and hands away from the paper infeed.
3. Pull the material out of the cutting mechanism.
4. If reverse running does not clear the material jam completely, please follow the
instructions in Chapter Clearing Residual Material.
Paper Shredder CC 415.4 / 518.4 / 624.4
Operating the Paper Shredder
Gi
AUTO button
AUTO button
17