Operation - Worx WG776E Anleitung

(See Fig. B2)
Step 2. Then push it forward. (See Fig. B2)
Step 3. Push down the back of the handle.
(See Fig. B2)
Step 4. Finally, clip the plastic clips over the
metal frame. (See Fig. B3)
WARNING: Don't fit the handle in
reversed direction. Fit the handle
as shown in Fig B1.
3. GRASS COLLECTION BAG FITTING
(See Fig. C1, C2, C3)
1) Turn the mower off, wait until blade stops
and remove safety key (6).
2) Pick up the grass collection bag by the
handle, and position grass collection bag
on the lower hooks (b) on the mower deck
(See Fig.C2).
3) Release the safety guard to lock the
grass bag into position. Ensure the grass
collection bag is installed securely
(See Fig. C3).
NOTE: Depress the grass collection bag
slightly to ensure that it is completely
installed.
4. REMOVING/EMPTYING
Hold the grass collection bag, lift the safety
12
flap (10) and hold up. Remove grass collection
bag (4).
WARNING! Always check the safety
flap can close the discharge outlet
tightly before using. Never lift the safety flap
(10) when the lawn mower is being used
without fitted grass collection bag.
5. FITTING/REMOVING BATTERY
(See Fig. D1, D2)
Depress the battery release button to release
battery pack from your mower (See Fig. D1).
After recharging, insert the battery pack into
mower's battery port (See Fig. D2). A simple
push and slight pressure will be sufficient.
NOTE: When removing the battery pack, hold
it firmly to avoid dropping and injury.
Cordless Lawn Mower

OPERATION

1. STARTING AND STOPPING
(See Fig. E1, E2)
WARNING! The blade continues
to rotate for a few seconds after the
machine is switched off. Allow the motor/
blade to stop rotating before switching "on"
again. Do not rapidly switch off and on.
STARTING
1) Insert safety key into the housing of the
switch box.
2) Slide the key to the right and hold in
position.
3) Pull the lever bar towards the handle and
the mower will start.
4) Release the safety key.
STOPPING
Release the switch lever.
2. WORK MODE DIAL (See Fig. F)
Status1: QUIET mode
Select QUIET mode when mowing in
everyday conditions, removing approximately
20mm of grass at a time.
Status2: TURBO mode
Set the dial to TURBO mode when cutting
dense or overgrown grass.
3. BATTERY STATUS LED'S (See Fig. G)
NOTE: The Status LED's will indicate the
battery condition when the button on
the battery is pressed.
The LED's constantly senses and displays the
battery condition as follows:
Press the button "POWERTEST" , the light
button is illuminated.
When the three green lights are illuminated,
the battery is in a highly charged condition.
When two lights (
battery is in a moderately charged condition.
When only one green light (
the battery charge is depleted.
Before using your new mower for the first
time, it is recommended that the unit be
charged overnight to ensure that the battery is
fully charged.
IMPORTANT
When only one light is illuminated,
) are illuminated, the
) is illuminated,
EN