bürkert 2103 Bedienungsanleitung Seite 44

replacement for control functions B and i
→
Clamp the valve body in a holding device.
(applies only to valves not yet installed).
→
Loosen the four body screws.
→
Remove the actuator from the body.
→
Unbutton or unscrew old diaphragm. If attachment is with a
bayonet catch, remove the diaphragm by rotating it through 90°.
→
Install new diaphragm.
→
Align diaphragm.
the marker flap of the diaphragm must be perpendicular to
the direction of flow (see "Fig. 33: Repairs")!
→
Place actuator back on the body.
→
Lightly cross-tighten the body screws without pressurization until
the diaphragm is between the body and actuator.
do not tighten screws yet.
→
Pressurize pilot air port 1 of the actuator with compressed air
(5 bar) (see "Fig. 33: Repairs").
→
Actuate the diaphragm valve twice.
→
Tighten the body screws to the permitted tightening torque (see
"Tab. 16: Tightening torques for diaphragms").
44
english
Type 2103
Repairs
dn tightening torques for diaphragms [nm]
epdM
8 2.5
15 3.5
20 4
25 5
40 8
50 12
Tab. 16: Tightening torques for diaphragms
ptFe
2.5
4
4.5
6
10
15