Philips GC6320 Bedienungsanleitung Seite 12

EnGlish
1
Problem
Water droplets
come out of the
soleplate.
Flakes and
impurities come
out of the
soleplate.
The soleplate is
dirty.
Dirty water
comes out of the
soleplate.
The iron
produces steam
continuously.
Cause
The selected ironing temperature is too
low for steam ironing.
When the iron has been set to a very
high temperature, the steam produced is
dry and hardly visible. It will be even less
visible when the ambient temperature is
relatively high and it will be entirely
invisible when the temperature has been
set to MAX.
The temperature dial may be set to a
temperature that is too low for steam
ironing.
You may not have switched on the iron.
You may have placed the steam tank on
an unstable and/or uneven surface.
When you start steam ironing and when
you have stopped steam ironing for a
while, the steam that was still present in
the supply hose will have cooled down
and condensed into water, which causes
water droplets to come out of the
soleplate.
The iron is new.
You may have ironed at a temperature
that is too high.
Impurities or chemicals present in the
water have deposited in the steam vents
and/or on the soleplate.
Too much scale and minerals have
accumulated inside the steam tank.
You have slid the steam activator to the
locking position.
Solution
Select a temperature of 2 or
higher.
Set the iron to a lower
temperature, e.g. 2, to check if
the iron is actually producing
steam.
Select an ironing temperature
that is suitable for steam ironing
(temperature settings 2 to
MAX).
Set the iron switch to 'on' and
wait until the iron is hot.
Place the steam tank on a stable
and even surface.
This is perfectly normal. Hold the
iron over an old cloth and press
the steam activator. The cloth
absorbs the drops. After a few
seconds, the steam production
normalises.
This is normal. The particles are
harmless ans stop coming out of
the soleplate when you have
used the iron a few times.
Clean the soleplate with a damp
cloth. Select the recommended
ironing temperature.
Clean the soleplate with a damp
cloth.
Rinse the steam tank. See chapter
'Cleaning and maintenance'.
Release the steam lock if you
only want to obtain steam when
pressing the steam activator.