System Setup; Positioning Of The Speakers; Speaker Setup And Testing; Power Handling - Philips FR735 Anleitungshandbuch

SYSTEM SETUP

CENTER
LEFT
SURROUND
(REAR)
LEFT

Positioning of the speakers

General hints for positioning
Avoid positioning the speakers in a corner or on the floor as
this will boost the bass tones too much. Placing the speakers
behind curtains, furniture, etc. will reduce the treble response.
The listener should always be able to "see" the speakers.
Each room has different acoustic characteristics and the
positioning possibilities are often limited. You can find the
best position for your speakers by referring to the picture
above.
As a minimum we recommend 5 speakers (2 front, a center,
2 surround) for good surround sound. It is possible to
reproduce some kind of surround sound with fewer speakers.
This is done by redirecting the signals which are foreseen for
the missing speakers to the existing ones. See "Menus" on
how to set up the receiver correctly for the number and size
of the speakers used.
Positioning the front speakers
The front speakers should be placed right and left in front of
the listening position like usual stereo speakers.
Positioning the center speaker
The center speaker should be placed in the center between
the two front speakers, e. g. underneath or on top of the TV.
The best height for the center speaker is the height of the
listener's ears (while seated).
Positioning the surround speakers
The surround speakers should face each other and be in line
with, or slightly behind the listener.
Positioning the subwoofer
A subwoofer can be used to enhance the bass performance of
your system dramatically. The subwoofer can be positioned
anywhere in the room, because it is not possible to locate the
source of deep tones. Nevertheless, you should not place the
subwoofer in the middle of a room, since the bass could be
severely weakened. Do not place any object on the subwoofer.
12

Speaker setup and testing

The relative volume of the speakers must be adjusted for
optimal surround sound. You should be at your usual listening
RIGHT
position when adjusting the speaker volume. See "Receiver
menus" on how to set up the receiver for the used speakers.
1 Press POWER / STANDBY to switch on the receiver.
SURROUND
(REAR)
RIGHT
2 Press TEST TONE on the remote control.
A test tone coming from the different speakers is
y
heard.
3 Press +/- REAR on the remote control to
increase/decrease the volume of the actual speaker.
4 Press TEST TONE on the remote control.
The test tone stops.
y
Note: If you are not completely satisfied with the volume
settings, we recommend making minor adjustments to
them during surround sound playback.

Power handling

If the receiver is used at very high power, it can produce
distortions which may seriously damage your speakers.
If distortions occur, reduce the volume and the tone controls
to a level where the sound is acceptable again.
To avoid overheating of the set a safety circuit has
been built in. Therefore your set may disconnect under
extreme conditions. If this happens, switch the set off
and let it cool down before reusing it.

Headphones

Connecting headphones to PHONES will switch off the
speakers. The receiver switches to
sound will be reduced to a stereo signal which is reproducible
by standard headphones.
Disconnecting the headphones switches on the speakers
again. If you wish to enjoy surround sound again, switch the
receiver back to surround sound.
STEREO and surround