Using The Machine For The Fi Rst Time Or After A Period Of Inactivity - Gaggia ESPRESSO DOSE Gebrauchsanweisung

ENGLISH
When the cup is fi lled press the hot water supply button (2)
again.
N.B.: The pump self-primer could be temporarily out of order
because of an "air bubble".
In this case water does not fl ow from brewing head (13), and
the following procedure should be followed:
a) Place a small frothing pitcher or mug under the steam
nozzle (6).
b) Turn the knob (24) counterclockwise to open the steam/
hot water dispensing tap and press the hot water/coffee
switch (2) to start dispensing.
c) After a few seconds, a steady stream of water will emerge
from the steam nozzle. Allow about one cup of water to
fi ll the pitcher. Press the hot water/coffee switch (2) and
close the steam/hot water tap (24) to stop dispensing.
NOTE: The temperature ready-light (5) will automatically
fl ash as the machine boiler heats. After switching on
the machine for the fi rst coffee, wait 6 minutes until the
machine has fully heated up, while for all subsequent
coffees the machine will be ready to use.
After coffee brewing, however, a little dripping may occur due
to wet coffee grinds in the fi lter-holder.
Caution: Never operate pump without water
in machine as damage to the pump may occur.
Damage of pump run without water is not covered
by warranty.
Using the machine for the fi rst time or
after a period of inactivity
This simple operation ensures an optimum brewing and must
be performed:
- at fi rst start-up;
- when the machine remains inactive for a long time (more
than 2 weeks).
N.B.: Dispensed water must be emptied into an adequate
drain. It is not suitable for food use. If the container fi lls
up, stop dispensing water during the cycle and empty it
before resuming the operation.
A (Fig.02) - Rinse the tank and fi ll it again with fresh
drinking water.
B (Fig.03) - Place a container under the steam wand
(Pannarello). Open the knob (24) slowly by turning it
counter-clockwise. Press the button for dispensing water
(2).
C Dispense half the water tank from the steam/hot water
wand. To stop dispensing, press the button for dispensing
water (2) once again and close the knob (24) by turning
it clockwise.
D Insert the fi lter holder into the brew unit from the bottom
(13) and turn it from left to right until it locks into pla-
ce.
E Place a suitable container under the fi lter holder.
F Press the brew button (2) and dispense all the water left
in the water tank. Once the tank is empty, stop dispensing
by pressing the brew button again (2). At the end, empty
the container.
G Fill the tank again and wait until the "correct temperature"
indicator light (5) turns on.
H Remove the fi lter holder from the unit by turning it from
right to left and rinse it with fresh drinking water.
I The machine is now ready to be used.
For further information on how to dispense hot water, please
refer to sections "How to brew a good Espresso
Coffee" and "Making Hot Water".
• 12 •