Troubleshooting; Possible Cause - AKG DMS 70 Quattro Bedienungsanleitung

Troubleshooting

7 Troubleshooting
Problem Problem
Problem Problem
No radio contact, the status LED (13) on the
transmitter is flashing green.
The connected transmitters switch off
automatically after two minutes without radio
contact with the receiver.
No sound
Noise, crackling, unwanted signals
Distortion
40

Possible cause

Possible cause
Possible cause Possible cause
The receiver is switched off, there is a power
failure, the transmitter is out of range, or a
new transmitter is not registered.
No sound because dual channel usage is not
permitted. Status LED (13) of the transmitter
flashes green, because another transmitter is
active on the same channel on the receiver.
Channel identification is not possible if
transmitter is not connected.
AC adapter is not connected to receiver
and/or power outlet.
Receiver is OFF.
Receiver is not connected to mixer or
amplifier.
VOLUME potentiometer (2) on receiver is at
zero.
Microphone or instrument is not connected to
bodypack transmitter.
Transmitter on/off switch (15) is set to "OFF"
or "MUTE".
Transmitter batteries are not inserted
properly.
Transmitter batteries are flat.
Transmitter is too far away from the receiver.
Obstructions between transmitter and
receiver.
No line of sight between transmitter and
receiver.
Receiver is too close to metal objects.
Antenna is in an unsuitable position.
Interference from other wireless systems, TV,
radio, mobile phone, walkie-talkies, or
defective electrical appliances or installations.
GAIN control (17 / 23) is set too high or too
low.
Interference from other wireless systems, TV,
radio, mobile phone, walkie-talkies, or
defective electrical appliances or installations.
Antenna position.
Remedy Remedy
Remedy Remedy
Set up the receiver. Make sure the transmitter
is in range of the transmitter.
Switch off the transmitter which is not
outputting an audio signal and assign this
transmitter to a free channel on the receiver.
Connect AC adapter to receiver and/or power
outlet.
Switch on receiver using on/off button (1).
Connect receiver output to mixer or amplifier
input.
Turn up VOLUME potentiometer
Connect microphone or instrument to audio
input (19) on bodypack.
Set transmitter on/off switch to "ON".
Insert batteries conforming to "+" and "-"
marks.
Replace transmitter batteries.
Move closer to the receiver.
Remove obstructions.
Avoid spots where you cannot see receiver.
Remove interfering objects or move receiver
away from them.
Move receiver to a different location. The best
transmission and reception performance is
achieved when the antennas (7) are pointing
upwards in the "normal position" (see
diagram on the title page).
Increase the internal error correction by
adjusting the AUTO CORRECTION switch to
the "Mid" or "High" setting.
Switch off interfering appliances within the
2.4 GHz ISM frequency range; switch off
defective appliances; have electrical
installations checked.
Turn GAIN control up or down until distortion
goes away.
Increase the internal error correction by
adjusting the AUTO CORRECTION switch to
the "Mid" or "High" setting.
Switch off interfering appliances within the
2.4 GHz ISM frequency range; switch off
defective appliances; have electrical
installations checked.
Move receiver to a different location. If dead
spots persist, mark and avoid them.
DMS 70 DMS 70 Quattro/Dual DMS 70 DMS 70