GRAPHITE 58G874 Bedienungsanleitung Seite 11

TRANSLATION OF THE ORIGINAL INSTRUCTIONS
CAUTION: BEFORE USING THE POWER TOOL READ THIS MANUAL CAREFULLY AND KEEP IT FOR FUTURE
REFERENCE.
PRECAUTIONS FOR USING HAMMER DRILL
Caution: Unplug the power cord from the mains socket before commencing any activities related to
adjustment, repair or maintenance.
During hammer operation use protective glasses or goggles, ear protection and protective
helmet (when there is danger of falling objects). Use of protection half-mask and anti-slip boots is
recommended. Use dust extraction systems whenever required by the nature of the work performed.
Prior to operation ensure the drill chuck of the hammer is properly fixed in its place.
During operation working tool may get loosened due to vibrations. Check carefully how the working
tool is fixed prior to operation. Unwanted slack may cause tool damage or accident during operation.
If the hammer is to be operated at low temperature or after long storage, allow the hammer to operate
for few minutes without load, for its internal elements get properly lubricated.
When operating the hammer held high, stand firmly on the ground and ensure there are no bystanders
below.
Always hold the hammer with both hands, use additional handle.
Do not touch moving parts of the hammer. Do not stop rotating spindle of the hammer with your
hands. Such behaviour can cause hand injury.
Do not direct operating hammer at other persons or at yourself.
When operating the hammer, hold it by insulated parts to avoid electric shock in case of damaging live
electrical wire.
Do not allow any dust to get inside the hammer. Use mineral soap and damp cloth to clean hammer
surface. Do not use petrol or other cleaning agents that could damage plastic parts.
When use of extension cord is necessary always remember to use appropriate one (up to 15 m, section
2
1.5 mm ; between 15 and 40 m, section 2.5 mm
Do not use three jaw drill chuck when the hammer drill is set to impact drilling or chiselling mode. This
chuck is designed only for regular drilling in wood or steel.
CAUTION! This device is designed to operate indoors.
The design is assumed to be safe, protection measures and additional safety systems are used,
nevertheless there is always a small risk of operational injuries.
CONSTRUCTION AND USE
Hammer drill is a hand-operated power tool with insulation class II. The tool is driven by single-phase
commutator motor. Hammer drill can be used for drilling holes in working mode with impact, digging
channels, or surface processing of materials such as concrete, stone, brick etc. Range of use covers repair
and building works, and any work from the range of individual, amateur activities (tinkering).
Use the power tool according to the manufacturer's instructions only.
DESCRIPTION OF DRAWING PAGES
Below enumeration refers to the device elements depicted on the drawing pages of this manual.
1. SDS-MAX chuck
2. Fixing sleeve
3. Operation mode switch
4. Lid for greasing inlet
5. Switch
6. Voltage indicator lamp
7. Bottom engine casing
8. Additional handle
HAMMER DRILL
58G874
DETAILED SAFETY REGULATIONS
2
). Extension cord should be unwound whole.
11