Cameo MULTI PAR Bedienungsanleitung Seite 15

OPERAtiOn:
DiMMER
In "DIMMER" mode, each of the four lights can be set to
an individual static colour through colour mixing. Press
the MODE button repeatedly until "DIMMER" appears on
the display. Then press ENTER and use the UP and DOWN
buttons to select the desired light (PANEL) 1 - 4 and confirm
with ENTER. Now the display shows the brightness values
of the individual colour LEDS (R = red, G = green, B = blue,
and W = white) of the selected light from 00 to 99. The
cursor is in the "R" field in the top line. Now use the UP
and DOWN buttons to set the brightness of the red LEDs.
Pressing ENTER confirms the input and moves the cursor
ahead to the "G" field for the green colour LEDs. Here,
again use the UP and DOWN buttons to set the brightness
to the desired value. The same procedure also applies to
the blue (B) LEDs. After confirming the value for the blue
LEDs by pressing ENTER, "DIMMER" appears on the display
again and you can select one of the four lights for colour
adjustment as described above.
POWER Out 1/2
The two Schuko Power POWER OUT jacks 1 and 2 can
be separately turned on and off using the menu settings.
Press the MODE button repeatedly until the display shows
"POWER OUT 1 - POWER OUT 2". Now press ENTER, the
cursor appears in the top line of the display. Now you can
use the UP and DOWN buttons to turn on or off the Schuko
mains socket: POWER OUT 1 (ON) or (OFF). After pressing
ENTER, the cursor jumps to the bottom line and you can
turn on or off the Schuko mains socket POWER OUT 2 in
the same way as described above. Confirm with ENTER.
15