Chapter 4 Advanced Configuration; How To Access The Web-Based Utility - Cisco Linksys WAG160N v2 Handbuch

Chapter 4
Chapter 4:
Advanced Configuration
After you have finished running the Setup Wizard on
the Setup CD-ROM, the Modem Router is ready for use.
You may wish, however, to change the Modem Router's
advanced settings. To do this, use the provided web-
based utility. You can access the utility via a web browser
on a computer connected to the Modem Router.
NOTE: For New Zealand,
instructions after accessing the web-based utility
in the Setup > Basic Setup screen:
RFC 2364
1. Select
Encapsulation drop-down menu.
2. For the Virtual Circuit ID, enter
and 100 for the VCI.
3. Select VC for Multiplexing.
Multimode from the DSL Modulation
4. Select
drop-down menu.
5. Enter your User Name and Password details
from your ISP.
6. Click Save Settings.

How to Access the Web-Based Utility

To access the web-based utility, launch the web browser
on your computer, and enter the Modem Router's default
IP address, 192.168.1.1, in the Address field. Then, press
Enter.
A login screen appears. Use the default user name and
password, admin, unless you changed them when you
ran the Setup Wizard. (You can set a new user name and
password from the Administration tab's Management
screen.) Click OK to continue.
Modem Router Login
If you are unable to log in, press the Reset button on the
back panel for at least 5 seconds, then wait for the device
to reset and try again.
Wireless ADSL2+ Modem Router
follow these
PPPoA
from the
0 for the VPI
Advanced Configuration
6