Betamotor ALP 4.0 Bedienungsanleitung Seite 101

BATTERY ICON - Vb LESS THAN 10.5 V
for at least 5 seconds. As a result, the clock will lose its setting and the time will have to
be set again.
All the other data are preserved.
Checking the active contents of the monitoring icons
It is always possible to check how many hours are to elapse or kilometres to be covered
before the monitoring icons are displayed.
Turn on the instrument while pressing MODE and SCROLL at the same time.
Holding down the buttons for about 5 seconds alternately displays the oil icon with the
hours to the next oil change and the service icon with the hours to elapse or the
kilometres to be covered (depending on the selected unit) before the vehicle requires
servicing. The test begins when the two buttons are released.
When the vertical bar blinks and min is
displayed, the battery voltage is less than
10.5 V. If the indication persists, the cause
will have to be determined.
IMPORTANT: If the battery is disconnect-
ed or its voltage is nearly zero, the instru-
ment loses its functionality. When this hap-
pens, the indicator and/or stand warning
lights light up and the LCD displays is lit
with no symbols. To restore the functionali-
ty of the instrument, unplug the connector
or disconnect the battery positive terminal
SELECTING Km/h or Mph
Press and hold down the SCROLL button
until the bars - - - - are displayed. When
the button is released, only a flashing Km/
h or Mph will be displayed to denote
which unit is active at the moment.
Briefly press SCROLL to toggle between
units.
To confirm the current selection, press and
hold down the SCROLL button until WS
is displayed in the bottom right corner.
When the button is released, the figure is
displayed again.
Pressing SCROLL briefly brings up the fig-
ure at left.
101
1
GB