Periods Of Non-Operation; Troubleshooting - Electrolux IK2070SR Benutzerinformation

remove pieces of ice that break away
before defrosting is complete.
4. When defrosting is completed, dry the
interior thoroughly.
5. Switch on the appliance.
6. Set the temperature regulator to
obtain the maximum coldness and run
the appliance for two or three hours
using this setting.
7. Reload the previously removed food
into the compartment.

6.5 Periods of non-operation

When the appliance is not in use for long
periods, take the following precautions:

7. TROUBLESHOOTING

WARNING!
Refer to Safety chapters.
7.1 What to do if...
Problem
The appliance does not op-
erate.
The appliance is noisy.
Audible or visual alarm is
on.
1. Disconnect the appliance from
2. Remove all food.
3. Defrost (if necessary) and clean the
4. Clean the appliance and all
5. Leave the door/doors open to prevent
Possible cause
The appliance is switched
off.
The mains plug is not
connected to the mains
socket correctly.
There is no voltage in the
mains socket.
The appliance is not sup-
ported properly.
The cabinet has been re-
cently switched on or the
temperature is still too
high.
The temperature in the
appliance is too high.
The door is left open.
The temperature in the
appliance is too high.
electricity supply.
appliance and all accessories.
accessories.
unpleasant smells.
WARNING!
If the cabinet will be kept on,
ask somebody to check it
once in a while to prevent the
food inside from spoiling in
case of a power failure.
Solution
Switch on the appliance.
Connect the mains plug to
the mains socket correctly.
Connect a different electrical
appliance to the mains sock-
et. Contact a qualified electri-
cian.
Check if the appliance stands
stable.
Refer to "Door Open Alarm"or
"High Temperature Alarm".
Refer to "Door Open Alarm"or
"High Temperature Alarm".
Close the door.
Contact a qualified electrician
or contact the nearest Au-
thorised Service Centre.
ENGLISH 65