Proper Use; Safety Devices; Before Startup; Start Up - Kärcher HD 10/15-4 F Bedienungsanleitung

Symbols on the machine
High-pressure jets can be dan-
gerous if improperly used. The
jet may not be directed at per-
sons, animals, live electrical equipment or
at the appliance itself.

Proper use

Use this appliance exclusively for cleaning
using high pressure jet with/without deter-
gent (e.g. food industry, disassembly
plants...).

Safety Devices

Overflow valve with pressure switch
While reducing the water supply/quantity
regulation at the pump head, the overflow
valve opens and part of the water flows
back to the pump suck side.
If the lever on the trigger gun is released
the pressure switch turns off the pump, the
high-pressure jet ist stopped. If the lever is
pulled the pump is turned on again.
Safety valve
The safety valve opens when the permissi-
ble operating pressure is exceeded; water
flows back to the suction side of the pump.
The overflow valve, pressure switch and
safety valve are set and sealed at the fac-
tory.
Setting only by customer service.
Water shortage safeguard
The lack of water fuse in the swimmer res-
ervoir shuts off the engine when the water
supply is insufficient (water pressure too
low).
The pump is thus protected from running
dry.

Before Startup

Unpacking
– Check the contents of the pack before
unpacking.
– In case of transport damage inform ven-
dor immediately
Check oil level
Î Unscrew the palm grip screw to lock the
appliance cover and open the appliance
cover.
Î Pull out the bottom cover plate on top
and unhook on the bottom.
Î Read the oil level display when the de-
vice is not running. The oil level must be
between the two markers on the oil res-
ervoir.
Activate deaeration of oil container
Î Open the lock on the appliance cover
and swivel the appliance cover up-
wards.
Î Pull out the bottom cover plate on top
and unhook on the bottom.
Î Cut off tip of oil container cover
Î Fasten the bottom cover plate and the
appliance cover.
Attaching the Accessories
Î Mount the nozzle onto the spray pipe.
Tighten covering nut firmly.
Î Connect ray tube to hand spray gun
Î Fasten the high pressure hose to the
high pressure connection.

Start up

Electrical connection
Warning
– The appliance may only be connected
to an electrical supply which has been
installed in accordance with IEC 60364.
– The voltage indicated on the type plate
must correspond to the voltage of the
electrical source.
11
English