Epson TM-J7000 Bedienungsanleitung Seite 17

Follow these steps to install an ink cartridge for the first time or to
replace an empty ink cartridge.
1. Make sure the printer is on. If it is not on, plug in the power
supply cable and turn on the power using the switch on the
front of the printer.
2. Make sure an INK OUT LED is on or flashing. When using two
colors, notice which ink cartridge INK OUT LED is on or
flashing; this indicates which cartridge is empty.
3. Be sure that roll paper is installed.
4. Open the ink cartridge cover using the tabs on the sides of the
cover. See illustration H.
5. Lift up the empty ink cartridge by using the tab. See
illustration I.
CAUTION:
Do not put your fingers inside the ink cartridge compartment or you
may be injured by a plastic projection.
Once the ink cartridge is used, the ink supply needle (plastic
projection) in the ink cartridge holder that supplies ink to the printer
is covered with ink. Avoid touching the cartridge holder to keep
your hands clean.
6. Take a new ink cartridge out of its packing and remove the
yellow tape. See illustration J.
CAUTION:
You must not remove any tape on which the EPSON logo is printed.
7. Carefully insert a new ink cartridge from the top and push it
firmly but gently until it clicks into place. Be sure the inserting
direction is correct, as shown in illustration K.
8. Close the ink cartridge cover completely.
Note:
The INK OUT LED will now be off.
The POWER LED flashes for approximately 1 minute as the ink
delivery system is charged. To save ink, this sequence will not be
executed every time you replace an ink cartridge. The time to
execute the sequence is controlled by the printer.
Note:
Do not turn off the power while the POWER LED is flashing. This will
waste ink because the printer has to re-start the ink charging process. Be
sure not to open the printer cover while the POWER LED is flashing.
TM-J7000/J7100 User's Manual 9
English