Installation; Installation Of Universal Mixing Valve Controller Hm 80; Wall Installation; Din Rail Installation - Honeywell HM 80 Montage Und Bedienung

Installation

5. Installation
WARNING Insufficient data transfer!
Interference of the radio receiver in the
devices through metallic objects and
further radio devices.
When selecting the operating site
►
ensure that the distance to radio
devices such as radio headphones,
cordless phones, etc. according to
the DECT standard amounts to at
least 1 m.
Ensure that there is sufficient
►
distance (> 30 cm) to metallic
objects.
Select another installation site if the
►
radio interference cannot be rectified.
WARNING Damage to the devices!
Short-circuiting through humidity,
moisture and incorrect connections.
Mount the devices at a site that is
►
protected against humidity and
moisture.
Observe the installation
►
specifications.
5.1. Installation of Universal Mixing
Valve Controller HM 80
Select the installation location so that the HM 80 can
communicate without interference by radio with the
CM67RFMV operating unit and is protected against humidity
and moisture.
The HM 80 can be installed in one of 2 ways:

• Wall installation

• DIN rail installation

5.1.1. Wall installation
Four 4.0-mm holes for installation are located on the HM 80.
Take the 161.5 mm installation height of the
HM 80 into account. If the HM 80 is installed at a
severe angle, the transformer must be on top to
allow for ventilation.
A
121
Dimensions of the HM 80 in mm
Break out the plastic in the pre-punched drill holes (A).
►
Drill the fastening holes.
►
If necessary, insert wall plugs.
►
Screw on the HM 80.
►
24
161.5
46
5.1.2. DIN rail installation
Installation
Place the housing on the DIN
►
rail from above (1).
Press the housing towards the
►
wall until it snaps into
place (2).
5.1.3. Installing the flow temperature
sensor
Select a suitable installation site
►
(see "Overview", Page 20).
Install the flow temperature
►
sensor as shown in the following
figure.
5.2. Installing the Chronotherm
CM67RFMV
Installation site CM67RFMV
Specify the installation site of the CM67RFMV.
►
Install the CM67RFMV using the wall holder (b) or the
►
desk holder (a).
The CM67RFMV is a radio-controlled device.
Installation should therefore be carried out in an
open room. A minimum distance of 30 cm from
any metal objects and distribution boxes is to be
observed and a minimum distance of 1 m from
other electrical devices such as radio, TV, etc.
Deinstallation
Push the housing up
►
(1), thus releasing
(disengaging) it from the
retainer.
Lift the housing from the
►
wall (2).