Lower Threading - Brother STAR 240E Bedienungsanleitung

1
2
1
37
2
1. Raise the needle to its highest position by turning the balance
2. Slide the button and open the cover.
1
3. Insert bobbin and deliver thread end through the slit, then pull the
4. Replace the bobbin cover. Place the left tab in place (see arrow
2
* You can begin sewing immediately without drawing up the

Lower Threading

CAUTION
Setting the bobbin improperly may cause the thread ten-
sion to loosen, breaking the needle and resulting in injury.
1 Wound evenly
2 Wound poorly
CAUTION
Be sure to turn off the power. If you accidentally press the
Start/Stop button or step on the foot controller and the
machine begins to operate, injury could result.
wheel toward you (counterclockwise) and raise the presser foot
lever.
1 Slide button
2 Cover
thread to cut.
CAUTION
Be sure the bobbin is set so the thread unrolls in the correct
direction. If the thread unrolls in the wrong direction, it may
cause the thread tension to be incorrect or the needle to
break.
1 at left), then press lightly on the right side (see arrow 2 at left)
until the cover clicks into place.
bobbin thread.