Troubleshooting - Medion MD 30159 Bedienungsanleitung

Troubleshooting

It can be difficult to check some of the settings listed below if your display is blank! In order to get an image on your screen so
that you can check the settings, it may be necessary to start your computer in safe mode.
• Windows 98/ME.
When starting your computer, press F8 before the Windows logo screen appears. Select Safe Mode.
• Windows NT 4
When starting your computer, select the boot option with [VGA Mode] at the end.
• Windows 2000/XP
When starting your computer, press F8 before the Windows logo screen appears. Select Enable VGA mode.
It may be necessary to reinstall your video driver while in one of these modes in order to reset the resolution and refresh rate.
No display on screen:
Check:
• Refresh rate frequency. The current image refresh frequency must be suitable for the TFT monitor.
• Power saving mode. Press any desired key and move the mouse to deactivate the mode.
• Signal cable pins. If pins are bent, please contact your call center.
• Set the appropriate values for your TFT monitor.
Picture runs or is not stable:
• Signal cable pins. If pins are bent, please contact your call center.
• Video card. Check whether the settings are correct.
• Image refresh frequencies. Select permissible values for your graphic settings.
• Remove any interfering equipment (portable telephones, loudspeakers, etc.) from the vicinity of your TFT monitor.
• Avoid using monitor extension cables.
Colors not displayed cleanly:
• Check the signal cable pins. If pins are bent, please contact your service dealer.
• Readjust the color settings using the OSD.
• Avoid using monitor extension cables.
Recycling
Packaging
All packaging and packaging materials that are no longer required can and should be recycled.
Device
At the end of its life, the appliance must not be disposed of in household rubbish. Enquire about the options for
environmentally-friendly disposal.
4 English