Using The Tuner; Specifications - Vox AC2 RhythmVOX Anleitung

Using the Effects
Entering Effect mode
Press the RM/FX button. Each time you press the RM/FX button, the mode will
change. When entering effect mode, all of the status LEDs will light, and the
effect will turn ON.
Selecting the effect
Press the TYPE button to select the effect type. Each time you press the TYPE
button, the effect type will change, and the status LEDs will light as shown in
the table below.
Effect ON/OFF
Press the ON/OFF button to switch the effect ON and OFF. When the effect is
OFF, the status LEDs will turn off.
Adjusting the effects
Turning the RHYTHM/FX knob allows you to adjust effect parameter 1. Turning
the RHYTHM/FX knob while pressing ON/OFF allows you to adjust effect pa-
rameter 2.
The parameters corresponding to each effect type are shown below.
Status LEDs Effect type
Chorus
Green Red Red
Delay
Red Green Red
Reverb
Red Red Green
Chorus
Green Green Red + Delay
Chorus
Green Red Green + Reverb

Using the Tuner

The tuner function on the AC2 RhythmVOX Bass enables to you to tune your
bass guitar that is connected to the BASS IN jack. The tuner will recognize the
pitch of your bass and will light up LEDs indicating the pitch relative to "E."
1. Press the RM/FX and TYPE buttons together. The rhythm and effect func-
tions will stop, and the tuner function will be engaged. The tuning status will
be shown by the status LEDs.
Indication during tuner mode (when no valid signal is input)
2. Play the open 4th string.
Be careful not to play other strings accidentally.
3. Tune the string so that only the middle indicator lights up green.
Tip
The tuner can recognize an E note at higher or lower octaves. You can
also use the tuner to tune to harmonics, or to tune other instruments.
4. Pressing either the RM/FX or the TYPE button will end the tuning.
Tip
After you tune the 4th string, tune the other strings using the 4th string as
a reference.
Parameter 2
Parameter 1
(ON/OFF button
(RHYTHM/FX knob)
+ RHYTHM/FX knob)
Chorus Mix Chorus Speed
Delay Mix Delay Time
Reverb Mix Reverb Time
Delay Mix Delay Time
Reverb Mix Reverb Time
Very sharp
Slightly sharp
In tune
Slightly flat
Very flat
About Sleep Mode
When there is no input sound(*) from the BASS IN jack, and about 30
minutes or more have passed since the RHYTHM/FX section knobs or
buttons have been operated, the amplifier will automatically enter sleep
mode (low-power state). In sleep mode, the status LEDs will turn off, and
the power LED will blink.
In this state, when a sound is inputted from the BASS IN jack or one of the
RHYTHM/FX section buttons are pressed, sleep mode will be canceled,
and the amplifier will return to normal operation.
* This includes low input levels, at which the tuner does not respond.
* Input sounds from the AUX IN jack will not cancel sleep mode.
* When the GAIN or VOLUME knobs are turned down, input sounds from
the BASS IN jack will not cancel sleep mode.
Tip
Exposing this amplifier to impact may register as an input sound,
which may cause the amplifier to take longer to enter sleep mode, or
cancel sleep mode if it has already begun.
Tip
The amplifier will enter sleep mode when using either the AC adapt-
er or battery power.
Tip
The amplifier will not enter sleep mode when it is playing a rhythm.

Specifications

Number of Rhythm Patterns:
Tempo Range:
Effect types:
I/O Jacks:
Output Power:
Speakers:
Power Source:
Battery Life:
Dimensions (W x D x H): 170 x 70 x 128mm / 6.69 x 2.76x 5.04 inches
Weight:
Accessories:
Optional Item:
The following parameters will be saved even after the power is turned
OFF: rhythm mode/effect mode selection, rhythm genre, rhythm variation,
tempo, effect ON/OFF, effect type, effect parameter 2.
* Specifications and appearance are subject to change without notice for
improvement.
- 8 -
81 (9 genres x 9 variations)
40–240 bpm
5
BASS IN jack (1/4" monaural phone jack, un-
balanced) x 1, AUX IN jack (1/8" stereo mini-
phone jack, unbalanced) x 1, PHONES jack
(1/8" stereo mini-phone jack) x 1
Approx. 2 W @ 4 ohms
3-inch, 8 Ohms x 2
AA batteries x 6 (alkaline batteries or zinc-car-
bon batteries); or, optional AC adapter
Approximately 20 hours (alkaline batteries)
620g / 1.37 lbs. (without batteries)
AA batteries x 6
AC adapter (500mA or greater, DC 9V
)