Bl = Automatic Backlight Control - Adam Equipment AELP 500 Bedienungsanleitung

StEPS*
7.
CALIbr
8.
rEPL
9.
StAB
10.
Aut
11.
12.
toP
13.
nE
14.
SuPP
15.
• Most functions only require a simple enable or disable (0 or 1) or
a number that is incremented. Select the function using [Func],
then press [Print] to view the current setting. Pressing [Print]
again will change the setting to the next value. Pressing [Func]
again will return to normal weighing.
• On other functions (marked *) select the function by pressing
[Func]. Press [Print] to enter the function menu. The program
will then prompt you to enter values depending upon the function
selected. It is necessary to use [Tare] to select a digit to change
and press [Print] to increment the flashing digit. When all digits
have been entered press [Func] to go to the next step.

bL = AUTOMATIC BACKLIGHT CONTROL

6.1
• If the scale includes a backlight, it can be either enabled or
disabled.
• To set the parameter press the [Func] key to show "bL"
• Press [Print] to see the parameter.
• Press [Print] to select either "bL= 0" or "bL= 1".
"bL= 0 "
"bL= 1"
• Press the [Func] key to return to weighing.
© Adam Equipment Company 2005
Enters check-weighing
Calibration routine
Sets RS-232 to transmit automatically or manually
Sets the RS-232 to print only when stable or at any time
Enables/disables the autozero function
t1
Enables/disables the automatic turn off
Enables/disables the maximum hold feature
Changes to measuring in Newtons
Displays the power supply voltage
Backlight is enabled.
Backlight is disabled.
8