Display Functions - Tunturi S40 Benutzerhandbuch

Power supply (Fig. E)
The trainer is powered by an external power supply.
Refer to the illustration to locate the trainer power
input.
NOTE
• Connect the power supply with the trainer
before connecting it to the wall outlet.
• Always remove power cord when
• machine is not in use.
Console (fig F)
1
3
2
1. Display
2. Tablet/ book support
3. Buttons
CAUTION
• Keep the console away from direct sunlight.
• Dry the surface of the console when it is covered
with drops of sweat.
• Do not lean on the console.
• Only touch the display with the tip of your finger.
Make sure that your nails or sharp objects do not
touch the display.
NOTE
• The console switches to standby mode when
the equipment is not used for 4 minutes. If the
console is in standby mode.

Display functions

Time window :
- Shows workout time during exercise
Range: 0:00 ~ 99:59
Speed window :
- Shows actual speed during exercise
Range: 0.0 ~ 99.9
RPM window :
- Shows revolutions per minute during exercise
Range: 0 ~ 999
Pulse window :
- Shows pulse in bpm during exercise
Distance window :
- Shows workout distance during exercise.
Range: 0.0 ~99.9
Calories window :
- Shows burned calories during exercise
Range: 0 ~999
Key functions
Recovery
- Test heart rate recovery status.
Down
- Decrease resistance level during workout.
- In setting selection lower value.
Mode
- Confirm setting or selection
Up
- Increase resistance level during workout.
- In setting selection upper value.
Reset
- When press and hold for 2 seconds, display will
reboot and start from main menu. (all shown data
will be lost)
- Reverse to main menu during presetting workout
value or stop mode
Start/ stop
- Start workout when in idle mode.
- Stop/ pause workout when in active mode.
1 7
English