Kärcher SB MU 908 Originalbetriebsanleitung Seite 57

Maintenance
1 Appliance component
2 Time until next maintenance (minus
symbol if maintenance is due)
3 Date of last maintenance
Version / info
Current value of the control voltage
Exterior temperature measured by exterior
temperature sensor.
Temperature monitoring
Water temperature warm water.
Status of washing stations
 Select the washing station number
(box) with the buttons LEFT and
RIGHT.
 Press the OK button.
The status of the selected washing station
is shown.
Currently selected washing programme.
Remaining value of the washing credit in
washing units.
Remaining run time in seconds.
Current pickup of the high pressure pump.
Active outputs of the pump electronics.
Run times of the individual washing pro-
grammes since system start-up.
Voltage supply to the remote controls.
Status rim cleaner
Current consumption of the pump rim
cleaner.
Active outputs of the pump electronics.
Status micro-emulsion
Current consumption of the pump micro-
emulsion (intensive cleaning complete).
Active outputs of the pump electronics.
20
-
EN
Status WSO
A Overview of status
B Details of status
1 Status of base exchanger
2 Status of reverse osmosis
3 Status of buffer tank for permeate
 Press the OK button.
 Select the desired display using the
"LEFT" and "RIGHT" keys.
Depending on the operating state, one of
the displays below may appear.
Base exchanger in operation.
Regeneration was activated, control has
been waiting for response from base ex-
changer for XXX seconds.
Base exchanger has been conducting re-
generation for XXX minutes.
The salt solution in the salt tank is regener-
ated. The process is completed within XXX
minutes. There can be no regeneration of
the base exchanger before then.
There was an error in the base exchanger.
57