Summer infant Gebrauchsanleitung Seite 3

USE:
Place the assembled bedguard on to the bed frame (mattress base). Adjust the length of the legs so that the bedrails, when in the locked (upright)
position, touch or slightly squeeze the sides of the mattress. For smaller mattress sizes, you may need to move the plastic leg supports to allow for
the full range of adjustment
If the mattress base is level with the side of the bed, the fitted bedguard should look like this:
If the mattress base is below the sides of the bed, you will need to adjust the legs to allow the assembled bedrail to fit between the bed sides.
The fitted bedguard should look like this:
NEVER use the bedrail with one of the sides removed. For safety, all parts must be used and correctly assembled.
To fold the bedrail side down, grasp the ends of the bedrail and use your fingers to press the buttons on both hinges; rotate the bedrail down until
it locks in the folded position. To raise the bedrail side, press the buttons on the hinges and rotate upwards. The hinge locks will engage
automatically, but always check they are secure (Figure N).
TO CLEAN:
To clean the bedguard, wipe the surface with a damp sponge, mild detergent, and cold water. Lay flat to dry.
Summer Infant, Inc.
1275 Park East Drive
Woonsocket, RI 02895 USA
1-800-268-6237
Summer Infant Europe, LTD.
First Floor, North Wing
Focus 31, Cleveland Road
Hemel Hempstead, HP2 7BW, UK
+44 (0) 1442 505000
customerserviceuk@summerinfant.com
12/16