Safety Guidelines; Description Of Function; Application; Technical Data - Honeywell SIMPLEX FF20 Einbauanleitung

1. Safety Guidelines

1. Follow the installation instructions.
2. Use the appliance
• according to its intended use
• in good condition
• with due regard to safety and risk of danger.
3. Note that the appliance is exclusively for use in the appli-
cations detailed in these installation instructions. Any
other use will not be considered to comply with require-
ments and would invalidate the warranty.
4. Please take note that any assembly, commissioning,
servicing and adjustment work may only be carried out by
authorized persons.
5. Immediately rectify any malfunctions which may influence
safety.
6. Make sure that the filter is neither exposed to to low nor
to high temperatures.
7. It is necessary during installation to observe codes of
good practice, to comply with local requirements and to
follow the installation instructions.

2. Description of function

Water flows through the filter mesh from outside to inside and
this traps dirt particles on the outer face of the filter. For
reasons of hygiene, the filter insert must be replaced at no
longer than six monthly intervals.
Activated Carbon cartridge filters out fine particles, eliminates
of unpleasant odours and flavours caused by chlorine or other
organic substances, removes of pesticides, insecticides,
chlorinate solvents.
Average life-span of activated carbon cartridges: about
6 months.

3. Application

Medium Water

4. Technical data

Installation position Horizontal with filter bowl downwards
Operating pressure Maximum 6.0 bar
Operating temperatureMaximum 45 °C
Connection size / " female,
3
4
1" male with
MU1H-1142GE23 R0114
GB
/ "-1" adapter
3
4
5

5. Scope of delivery

The filters comprise:
• Duplex or Simplex housing, wall bracket, wall bracket
screws
• Clear filter bowl
• Fine filter 25 μm
• Activated Carbon insert
• ¾" female thread
• ¾"-1" male adapter
• Ring wrench for filter bowl

6. Options

FF40 Duplex water filter: mesh size 25µm combined
with activated carbon
FF20-MF Simplex water filter: mesh size 25µm
FF20-AC Simplex activated carbon

7. Assembly

7.1. Installations Guidelines
• Install in horizontal pipework with filter bowl downwards
- This position ensures optimum filter efficiency
• Install shutoff valves before and after the filter
• Ensure good access
- Degree of contamination can be seen with clear filter
bowl
- Simplifies maintenance and inspection
• The installation location should be protected against frost
• Do not install in places where there is strong sunlight
7.2. Assembly instructions
1. Thoroughly flush pipework
2. Install filter
• Note flow direction (indicated by arrow)
• Install without tension or bending stresses
3. The appliance is ready for use

8. Maintenance

8.1. Inspection
Regular inspection of filter insert - approx. every 4
month.
• Replace if contamonation is high!
8.2. Maintenance
8.2.1. Filter bowl
1. Close shutoff valve on inlet and outlet
2. Release pressure on outlet side
3. Unscrew filter bowl
4. Remove filter cartridge
5. Insert filter cartridge in new filter bowl
6. Screw filter bowl in place
7. Open shut-off valve on inlet
8. Slowly open shutoff valve on outlet
Honeywell GmbH