Briggs & Stratton 020225 Bedienungsanleitung Seite 8

Briggs & Stratton Generac Generator Discount Parts Call 606-678-9623 or 606-561-4983
NOTE: It may be necessary to move the handle supports
from side to side in order to align the handle so it will slide
over the handle supports.
2. Insert carriage bolts through holes from outside of unit
and attach plastic knob on inside of handles (Figure 4).
Tighten by hand.
Figure 4 — Secure Handle
3. Insert multi–colored spray tips in spaces provided in
handle.
Add Engine Oil and Fuel
• Place pressure washer on a level surface.
Any attempt to crank or start the engine before it has
been properly filled with the recommended oil will result
in equipment failure.
• Refer to engine manual for oil and fuel fill information.
• Damage to equipment resulting from failure to follow this
instruction will void warranty.
• Refer to engine operator's manual and follow oil and fuel
recommendations and instructions.
NOTE: Check oil often during engine break–in. Refer to
engine operator's manual for recommendations.
CAUTION
www.mymowerparts.com
ASSEMBLY
Connect Hose and Water Supply to
Pump
IMPORTANT: To avoid pump damage, you must assemble
the nozzle extension to the spray gun and attach all hoses
before you start the engine.
1. Uncoil high pressure hose and attach quick connect
end of hose to base of spray gun (Figure 5). Pull down
on collar of quick connect, slide onto spray gun and let
go of collar.Tug on hose to be sure of tight connection.
Figure 5 — Connect High Pressure Hose to Spray Gun
NOTE: Remove and discard all pump shipping caps before
attaching hoses.
2. Similarly, attach other end of high pressure hose to
high pressure outlet on pump (Figure 6). Pull down on
collar of quick connect, slide onto pump and let go of
collar. Pull on hose to be sure of tight connection.
Figure 6 — Connect High Pressure Hose to Pump
8
Connect high
pressure hose
here.
Connect high
pressure hose here