TERMA MEG Gebrauchsanweisung Seite 22

MOA IR
Turning the device on with the button will
result in the radiator heating up to the set
temperature. After reaching the set temper-
ature the device will turn off and on regular-
ly in order to maintain the set temperature.
The construction of the device as well as
the physical characteristics of the heating
agent inside the radiator, influence the way
in which the heat is distributed — the tem-
perature of the bottom pipes on the radia-
tor (especially the two located at the very
bottom of the radiator), may be lower than
the temperature of the remaining parts of
the radiator — this is a normal phenomenon.
Temperature increase
In order to increase the temperature of the
radiator, press
required; the correct number of diodes will
start blinking. The last blinking diode indi-
cates the set temperature, whilst the last di-
22
User manual MEG, DRY, MOA, REG 2, REG 3
temperature regulation
dryer On/Off switch
IR sensor
once or several times as
ode which shines constantly, indicates the
current temperature. The remaining diodes
will start shining constantly on reaching sub-
sequent temperature levels.
Temperature decrease
In order to decrease the temperature of the
radiator, press once or several times as
required; the correct number of diodes will
start blinking. The last diode, which shines
continuously, indicates the set temperature
whilst the last blinking diode indicates the
current temperature. The remaining diodes
will start fading on reaching subsequent tem-
perature levels.