Menu Setting Explanation; Beep Signals - Batavus ION Bedienungsanleitung

2.8

Menu setting explanation

2.8.1 Lighting
You can set whether you wish the lights to be switched on automatically or
whether you wish to do this manually under Lighting.
If you select Auto, the bicycle lighting will be switched on and off
automatically. A light sensor will continuously measure the quantity of light
and will switch the lights on and off based on this.
If you select Manual, the bicycle lighting will only be switched on or off
when you use the lights button on the control unit.

2.8.2 Beep Signals

You can set whether and when you wish to hear beep signals under
Beepers.
If you select On, the display will emit five long beeps when there is a
message on the display. In addition, you will also hear a short beep signal
when you press the control unit buttons.
If you select On alerts, the display will emit five long beep signals when
there is a message. Your display will not emit beep signals with this setting
when the control unit buttons are pressed.
If you select Off, the display will not issue beep signals when operating the
control unit nor when there are alerts.
2.8.3 Calibration
If the peddling assistance is reduced in due course, the electronics may
have to be calibrated.
1. Stand next to the bicycle.
Do not exert force on the pedals.
2. Switch off the lights (H).
3. Keep the lights button pressed for at least two
seconds until the message is issued that the
calibration has been completed.
59
57