Bosch TR5000 11/13 EB Gebrauchsanleitung Seite 7

8 A fault, what to do?
WARNING:
Attention!
▶ Repairs must only be carried out by an authorised technician.
Improper repairs can lead to risk of serious injury to the user.
8.1 Faults that the customer can troubleshoot himself
Fault
Water flow-rate is too low.
A high water temperature is set,
but it is not reached.
The water is not warm.
LED status display flashes red.
If the fault could not be eliminated, please call customer service.
8.2 Faults that the customer service specialist should troubleshoot
Fault
Water flow-rate is too low despite
cleaning of filter using the water tap or
showerhead.
8.3 Faults that are automatically remedied
Fault
From time to time, cold water flows out. The air sensor in the appliance detects air in the water
9 Guarantee
The guarantee conditions for this appliance are as defined by our
representative in the country in which it is sold.
Details regarding these conditions can be obtained from the dealer from
whom the appliance was purchased. The bill of sale or receipt must be
produced when making any claim under the terms of this guarantee.
TR5000 – 6 720 876 034 (2017/07)
Cause
The filter in either the water tap or the showerhead
is clogged.
The continuous-flow heater is connected
to a thermostatically-controlled water tap.
The fuse in the fusebox has tripped/blown.
The supply temperature has dropped or the
appliance has reached the power limit.
Fault in the appliance.
Cause
A filter in the appliance is clogged.
Cause
and momentarily switches the heating element off.
If your appliance does not operate as required, it is often due to a very
minor problem. Please check whether you can remedy the fault yourself
by using the following guidelines. You will save yourself the costs of an
unnecessary visit by customer service personnel.
Solution
Remove the filter and either clean it or descale it.
Set the temperature on the continuous-flow heater
to "Rinsing"
Check the fuse in the fusebox.
Set the temperature lower e. g. "Washing hands"
Please contact customer service.
Solution
Get a servicing expert to clean the appliance.
Solution
After a few seconds, the continuous-flow heater
automatically goes back into operation.
A fault, what to do?
.
.
7