Troubleshooting - switel DET147 Bedienungsanleitung

11

Troubleshooting

Should problems arise with the telephone, refer to the following
information. In the case of claims under the terms of guarantee, contact
your sales outlet.
Faults
− No connection to
base station possible
− There is no dialling
tone
− The telephone does
not signal calls
− Interruptions in the
connection
− The handset no lon-
ger responds
− The BATTERIE
− message appears
after a short time
− No caller phone
number display
(CLIP)
− Troubleshooting −
Corrective measures
− The handset is too far from the base station.
− Check that you have used the correct PIN
code for the registration.
− The telephone line is not connected pro-
perly or is defective. Only use the telephone
connection cable supplied.
− Test whether the telephone connection is in
order by using another telephone.
− The rechargeable standard batteries are
empty or defective.
− The handset is too far from the base station.
− Check that the ringer is activated.
− Dialling mode set incorrectly (refer to Chap-
ter 8.5).
− The handset is too far from the base station.
− The base station is in an unsuitable loca-
tion.
− Reset all the functions to their default set-
tings. Before doing so, disconnect the
power adapter plug briefly from the power
socket. For information on default settings,
refer to Chapter 8.6.
− Place the handset in the base station for 14
hours. If this does not help, replace the re-
chargeable standard batteries.
− The caller number display function is an op-
tional service offered by telephone network
providers. Contact your network provider for
further information.
141