The Weighing Hand Pallet Truck; Taking The System Into Operation; Use - Mettler Toledo BTA425 Bedienungsanleitung

2. THE WEIGHING HAND PALLET TRUCK

2.1. TAKING THE SYSTEM INTO OPERATION

To activate the weighing system, turn it on using the on/off (1) button on the
terminal.
After 3 to 5 minutes the electronics and load cells have reached the operational
temperature. Before this, inaccuracies of up to ca. 0.3% may occur.
It is recommended not to lift loads before the zero-point correction has been
executed.

2.2. USE

The power supply to the system takes place through an exchangeable battery pack.
With a completely charged battery pack the total weighing time is about 35 hours (on
a system without a printer).
The voltage level of the battery is shown in the display. When the battery indication
only shows one bar, the battery should be charged. When the battery is completely
empty, the weighing system switches off.
When charging, it is necessary to charge the battery for at least 6 hours. This will
prevent loss of battery capacity.
If you use the system in shift work or if the system has a built-in printer, it is
recommended to purchase a supplementary battery pack.
The battery can be charged on the adapter supplied with the charger. When the
battery is charging, the LED on the charger is lit. When the LED turns off, the battery
is fully charged.
It is not possible to overload the battery because the charger switches off
automatically.
The weight must be lifted freely: without touching the housing of the indicator or other
pallets:
Wrong way of lifting the load
The accuracy of the weighing system diminishes with circa 0.1% per degree starting
from a tilted position of 2°. This effect also occurs with pits/pot-holes in the floor. An
even floor is optimal.
Correct way of lifting the load
E
N
G
L
I
S
H
5