EN
Fume Eliminator
1
Preface
This manual is for the correct installation, use and maintenance of this product.
Read it carefully before using this product or carrying out maintenance.
Replace the manual immediately if lost.
This product has been designed to meet the requirements of relevant EC
directives. To maintain this status, all installation, repair and maintenance
work for this product is to be carried out by qualified personnel using only
original spare parts. Contact the nearest authorized distributor or Nederman for
advice on technical service and obtaining spare parts.
Nederman continuously improves its products' design and efficiency through
modifications, and reserves the right to do so without introducing these
improvements to previously supplied products. Nederman also reserve the right
to, without previous notice, modify data and equipment as well as operating
and maintenance instructions.
2
Notices
This document contains important information that is presented either as a
warning, caution or note. See the following examples:
WARNING!
Warnings indicate a potential hazard to the health and safety of personnel, and
how that hazard may be avoided.
CAUTION! Type of risk.
Cautions indicate a potential hazard to the product but not to personnel, and
how that hazard may be avoided.
NOTE!
3
Description
3.1
Function
See Figure 2.
1.
Handel/combined lock for the coarse separator.
2.
Coarse separator.
3.
Switch.
4.
Time delay (only units with automatic mode).
5.
AUTO ON indicates that the current supply to the electronics is operative
(only units with automatic mode).
6.
FILTER FULL (6) Indicates that the filter is full with welding fume
particulate and requires changing as soon as possible to ensure maximum
suction effectiveness. Is only indicated when the fume eliminator is in
operation (only units with automatic mode).
7.
Holder for welding or welding return cable (only units with automatic
mode).
8.
Exhaust.
10
Type of injury.
Notes contain other information that is important for personnel.