Cabling Bracket For Control & Main Cable; Power Wiring Connections - Parker AC30V-Serie Sicherheits- Und Schnellstartanleitung

1-7
Cabling Bracket for Control & Main Cable
When bottom cover is removed you can install the cabling brackets, if required.
The cabling brackets are standard with C2 filtering products and can be obtained from Parker using the following
part numbers:
Frame E Illustrated

Power Wiring Connections

Feed the power supply and motor cables into the
drive under the cable clamps using the correct
cable entries, and connect to the power terminals.
Tighten all terminals to the correct tightening
torque, refer to the 'Terminal Tightening Torques'
table in the AC30V Product Manual, Chapter 4
'Installation'.
Note: Cable clamps and earthing brackets are only supplied with a C2 EMC Filter kit (see previous page
for part numbers), see page 1-11 for motor termination details.
The part numbers for cabling brackets are:
Frame D – LA501935U001
Frame E – LA501935U002
Frame F – LA501935U003
Frame G – LA501935U004
Frame H – LA501935U005
English
Control cable
wiring bracket
Main cable
wiring bracket