Operation In Stereo Mode; Operation In Parallel Mode - Alto APX2000 Kurzanleitung

OPERATION IN STEREO MODE

The APX2000 provides three operating modes: stereo mode, parallel (mono) mode and bridged mode, you can
decide each specific operating mode according to your actual application circumstance.
In STEREO MODE, channel 1 and channel 2 operate independently (as a conventional stereo amplifier). The channel
1 input signal will be output from the channel 1 output connectors, and the channel 2 input signal will be output from
the channel 2 output connectors.

OPERATION IN PARALLEL MODE

In this mode, the channel 1 input signal will be outputted from the output connectors of both channels. The channel 2
input jack is not used and the channel 1 and 2 volumes can be adjusted independently. Use Parallel Mode when you
want to drive two speakers with only one input signal keeping separate control of the volume of the two channels.
NOTE: Since you are not using the channel 2 input you can use this socket to "daisy-chain" to another amplifier.
CH1 CH1
CH3 CH3
STEREO
CH1 CH1 CH2 CH2
CH1 CH1 CH2 CH2
CH3 CH3 CH4 CH4 CH3 CH3 CH4 CH4
CHANNEL 1
PARALLEL
CH2 CH2 CH1 CH1 CH2 CH2
CH4 CH4 CH3 CH3 CH4 CH4
CHANNEL 3
CHANNEL 1
CHANNEL 2
BREAKER BREAKER
AC INPUT AC INPUT
CHANNEL 4
5
CHANNEL 2
BREAKER BREAKER
AC INPUT AC INPUT