34 www.aeg.com
Problem
"dEMo" appears on
the display.
The compressor runs
continuously.
Water flows inside
the refrigerator.
Water flows on the
ground.
The temperature in
the appliance is too
cold.
The temperature in
the appliance is too
warm.
The temperature in
the refrigerator is
too warm.
Possible cause
The appliance is in dem-
onstration mode.
The Temperature regula-
tor may be set incorrectly.
The door is not closed
correctly.
The door has been
opened too frequently.
The food temperature is
too high.
The room temperature is
too high.
The water outlet is clog-
ged.
Food prevent that water
flows into the water col-
lector.
The melting water outlet
does not flow in the evap-
orative tray above the
compressor.
The Temperature regula-
tor may be set incorrectly.
The Temperature regula-
tor may be set incorrectly.
The door is not closed
correctly.
The food temperature is
too high.
There is no cold air circu-
lation in the appliance.
Large quantities of food
to be cooled were put in
at the same time.
Solution
Keep pressed approxi-
mately 10 sec the OK but-
ton since a long sound of
buzzer is heard and the
display shut off for a short
while: appliance start
works regularly.
Set a warmer temperature.
Refer to "Closing the
door".
Do not keep the door
open longer than necessa-
ry.
Let the food temperature
decrease to room temper-
ature before storage.
Decrease the room tem-
perature.
Clean the water outlet.
Make sure that food do
not touch the rear plate.
Attach the melting water
outlet to the evaporative
tray.
Set a warmer temperature.
Set a lower temperature.
Refer to "Closing the
door".
Let the food temperature
decrease to room temper-
ature before storage.
Make sure that there is
cold air circulation in the
appliance.
Insert smaller quantities of
food to be cooled at the
same time.