Retraction Prior Initial; Operation; Notes On Operation; B) Check The Screw - Holzmann ED 300FD Betriebsanleitung

 Clamp a workpiece in the lathe chuck , lathe or turning the clamping jaws of the chuck com-
pletely together before turning on the lathe.

13.5.1 Retraction prior initial

The retraction should be performed with the lowest screw speed. Let the machine at this speed
for about 1 hours walk . Check out irregularities , such as unusual noises , imbalances , etc. If
everything is in order, gradually increase the speed .
14

OPERATION

14.1

Notes on Operation

b) Check the screw

Check all bolted connections and tighten them if necessary.

c) Checking the oil level

Check it the oil level and fill it if necessary after some oil
14.2 operation
Setting each time you start speed control to the lowest level !
NOTE: Failure to comply results in damage to the engine and loss of

14.2.1 Engine starting / stopping

If you want to press the ON OFF switch, the com-
bined EMERGENCY STOP switch must be in the
open state. They pull to open the emergency OFF
switch to the left
 To start, press the green button˝I˝
 To top, press the red button˝O˝
INFO: In the closed state of the main switch can be operated as an

14.2.2 Setting the spindle speed

The speed (high / low) is selected by the speed adjustment ( 16).
The set speed is displayed on the speed display (20).
HOLZMANN MASCHINEN GmbH www.holzmann-maschinen.at
W A R N I N G
warranty !
METALLDREHMASCHINE / METAL TURNING LATHE ED 300FD
OPERATION
EMERGENCY STOP switch
Seite 34