3. Installation
3.1 General instructions
DANGER OF FIRE!
When installing the device, make sure there is no highly inflammable material
(decoration articles, etc.) in between a distance of min. 0,5 m.
The projectors can be installed in any position without altering its operation characteristics.
Make sure that the device is fixed properly ! Ensure that the structure
to which you are attaching the projectors is secure
For fixing the projectors use the hole provided in the bracket. The hole in the adjustable mounting bracket has a
diameter of 10 mm.
For overhead use, fit a safety chain or cord.
3.2 Connection to the mains
Connect the projector to the mains with the enclosed power-plug.
3.3 DMX-512 connection / connection between projectors
Connect the controller to the projector or one projector to another only by a stereo shielded cable and 3-pin XLR-
plugs. We recommend to use the FUTURELIGHT CP16/SC-3 controller designed for this scanner.
Caution: At the last scanner, the DMX-cable has to be terminated with a 120
resistor. Solder the resistance
W
into a 3-pin XLR-plug and plug it in the DMX output of the last scanner.
The wires must not come into contact with each other, otherwise
the projectors will not work at all, or will not work properly.
1 6