Adjustments - Pattfield PE-1200WS Originalbetriebsanleitung

grInDIng
1 Attach the grinding guard to the tool
and align it, that the operator is pro-
tected from sparking. close the guard
release lever.
caution! Make sure the tool is
switched off and unplugged.
WHEEL THIcKNESS: 6 - 8 MM
3A Install a straight grinding wheel with
the lock nut 4 so that the flange points
towards the machine.
Press and hold the spindle lock but-
2
ton and tighten the lock nut
the wrench.
cuttIng
1 Attach the cutting guard to the tool and
align it that the operator is protected
from sparking. close the guard release
lever.
caution! Make sure the tool is
switched off and unplugged.
WHEEL THIcKNESS: 2 - 4 MM
3A Install a cutting wheel with the lock
nut 4 so that the flange points away
from the machine.
Press and hold the spindle lock but-
2
ton and tighten the lock nut
the wrench.
SpeeD SettIng
1 Use speed dial 1
speed.
caution! Pay attention not to block
the tool at low speed.
4
with
4
with
to set the operation
2 If the grinding guard is not securely
held in place, the preload of the release
lever can be increased by use of the
wrench.
WHEEL THIcKNESS: 6 - 8 MM
3B Install a depressed grinding wheel with
the lock nut 4 so that the flange points
towards the machine.
Press and hold the spindle lock but-
2
ton and tighten the lock nut
the wrench.
2 If the cutting guard is not securely held
in place, the preload of the release lever
can be increased by use of the wrench.
WHEEL THIcKNESS: 2 - 4 MM
3B Install a depressed cutting wheel with
the lock nut 4 so that the flange points
away from the machine.
Press and hold the spindle lock but-
2
ton and tighten the lock nut
the wrench.
2 The operation speed can be set in six
steps from:
mIn = 3000/min - mAX = 12000/min
caution! Make sure not to cover the
ventilation slots during operation.
4
with
4
with
EN 105