Installation; Protective Measures; Maintenance And Cleaning - Oase LunAqua Classic LED Set 1 Gebrauchsanweisung

Installation

The unit is supplied fully assembled as a complete set with a transformer and one or three LED spotlights, including
bulbs.
Installation (B-C)
• The foot can either be stood on the ground or bolted to a firm base or load bearing wall (B).
• Position the unit in such a way that it does not present a hazard to anybody.
• Adjust the tilt of the light (C, 1) and fix it at this angle with the screw connection (C, 4).
• Connect the plug of the spotlight connection cable to the socket on the transformer and tighten the union nut (C, 5)
hand-tight.
Commissioning/start-up
Note
Sensitive electrical components. Incorrect connection will destroy the unit.
• Do not connect the unit to a dimmable power supply.
Attention! Dangerous electrical voltage.
Possible consequences: Death or severe injury.

Protective measures:

• Electrical units and installations with a rated voltage of U > 12 V AC or U >30 V DC located in the water: Isolate the
units and installations (switch off and disconnect from the power supply) before reaching into the water.
• Isolate the unit before starting any work.
• Secure the unit to prevent unintentional switching on.
Switching on: Insert the power plug of the transformer into the socket.
• Check the function of the spotlights.
Switching off: Disconnect the transformer power plug.

Maintenance and cleaning

Attention! Dangerous electrical voltage.
Possible consequences: Death or severe injury.
Protective measures:
• Electrical units and installations with a rated voltage of U > 12 V AC or U >30 V DC located in the water: Isolate the
units and installations (switch off and disconnect from the power supply) before reaching into the water.
• Isolate the unit before starting any work.
• Secure the unit to prevent unintentional switching on.
• Ensure that no moisture can enter the unit.
Cleaning the unit
If necessary, clean the unit with clear water using a soft brush.
Replacing the bulb (D)
• Unscrew the threaded ring (6).
• Remove the glass pane (7) and O ring (8) and check for damage. Replace if necessary.
• Remove the defective bulb (9) from the housing (1).
• Insert a new bulb (do not touch with your hands, use a cloth or similar).
Only use original bulbs from OASE. Light bulb rating: max. 1 W.
• Reassemble the unit in the reverse order. Ensure that the O ring (8) is correctly positioned.
• Reconnect to the power supply and check the function.
- EN -
9