Troubleshooting And Fault Elimination; Troubleshooting; Error Messages - Lenze EEPM1RA Betriebsanleitung

Troubleshooting and fault elimination

5

Troubleshooting

5.1 Error messages
Display
CHANGE BATTERY!
FILE VER INCOMP!
READ ONLY FILE!
EPM DAMAGED!
EPM MISSING!
EPM TOO SMALL!
INTERNAL ERROR!
INVALID INT CFG
WRONG PASSWORD
20
Cause
The battery voltage is <3.6V (the
message is displayed after switching
on the EPM programmer.
The parameter file or servo EPM
you are attempting to edit has a
different parameter version than
the configuration file of the EPM
programmer.
You have tried to edit or delete the file
DEFAULTS.
The EPM in the EPM PORT is
defective.
The EPM is not placed correctly in the
EPM PORT.
There is no EPM in the EPM PORT to
which you are attempting to transfer
data or edit..
EPM in EPM PORT does not have
sufficient memory for the file you are
attempting to copy.
Internal device error.
The configuration file of the EPM
programmer is invalid.
Attempting to reconfigure the
EPM programmer without a valid
configuration EPM.
The access protection is activated and
you have entered the wrong password
after switch-on.
ENGLISH
Remedy
Change the batteries
( See Section 3.2)
You can only edit a file if the
parameter version corresponds to
the configuration file of the EPM
programmer.
See Section 4.13 on changing the
programmers internal configuration.
The file DEFAULTS cannot be edited
or deleted.
Exchange the defective EPM.
Plug the EPM correctly in the PORT.
Press the menu key now to return to
the main menu.
Plug an EPM in the EPM PORT.
Replace the EPM in the EPM PORT
with an EPM that has a higher memory
capacity.
Please contact your Lenze
representative.
Please contact your Lenze
representative.
Insert a valid configuration EPM into
the MASTER PORT. See section 4.13.
Only if you enter the correct password
will you have full access to the main
menus.
If you press the MENU key, the
process is aborted and you have only
restricted access to the main menus.
(see Section 4.16 )
If you have forgotten your
password, please contact your Lenze
representative.