Siemens SINUMERIK 802C Inbetriebnahme Seite 96

Technischer Anhang
6.1 Liste der Maschinen- und Settingdaten
34090 REFP_MOVE_DIST_CORR
mm, Reference point offset/absolute offset distance-coded
Grad
_always 0.0
34092 REFP_CAM_SHIFT
mm, Electr. cam offset of incremental measuring systems with equidistant zero marks
Grad
_always 0.0
34100 REFP_SET_POS
mm, Reference point value/irrelevant for distance-coded system: 0 ... 3
Grad
_always 0., 0., 0., 0.
34110 REFP_CYCLE_NR
- Sequence of axes in channel-specific referencing
-1: No obligatory reference point for NC Start
0: No channel-specific reference-point approach
1-15: Sequence in channel-specific reference point approach
_always 1
34200 ENC_REFP_MODE
- Type of position measuring system
0: No ref. point appr.; if absolute encoder exists: REFP_SET_POS accepted
1: Zero pulse (on encoder track)
_always 1
35010 GEAR_STEP_CHANGE_ENABLE
- Gear change possible. Spindle has several gear steps
_always 0
35040 SPIND_ACTIVE_AFTER_RESET
- Own spindle reset
_always 0
35100 SPIND_VELO_LIMIT
Umdr/min Maximum spindle speed
_always 10000
35110 GEAR_STEP_MAX_VELO
Umdr/min Maximum speed for gear change (gear stage no.): 0..5
_always 500, 500, 1000, 2000, 4000,
8000
35120 GEAR_STEP_MIN_VELO
Umdr/min Minimum speed for gear change (gear stage no.): 0..5
_always 50, 50, 400, 800, 1500, 3000
35130 GEAR_STEP_MAX_VELO_LIMIT
Umdr/min Maximum speed of gear stage (gear stage no.): 0...5
_always 500, 500, 1000, 2000, 4000,
8000
35140 GEAR_STEP_MIN_VELO_LIMIT
Umdr/min Minimum speed of gearsetp (gear stage no.): 0...5
_always 5, 5,10, 20, 40, 80
6-96
-
0.0
-
-1
0
***
***
0.0
0.0
0.0
0.0
0.0
POWER ON
- DOUBLE
RESET
plus DOUBLE
RESET
- DOUBLE
RESET
31 DWORD
POWER ON
6 BYTE
POWER ON
*** BOOLEAN
POWER ON
*** BOOLEAN
POWER ON
plus DOUBLE
NEW CONF
plus DOUBLE
NEW CONF
plus DOUBLE
NEW CONF
plus DOUBLE
NEW CONF
plus DOUBLE
6FC5 597-3AA20-0AP2 (01.02) (IBN)
2/7
2/7
2/7
2/7
2/7
2/7
2/7
2/7
2/7
2/7
2/7
2/7
SINUMERIK 802C