Unpacking And Setting Up; Operating The Appliance - Silvercrest SEAD 1800 B1 Bedienungsanleitung

RP89015 Einkochautomat LB6so Seite 7 Freitag, 22. Februar 2013 4:18 16
• Only place the appliance on a level,
dry, non-slip surface so that the
appliance can neither fall over nor slide
off.
• Do not place the appliance immediately
underneath a suspended cupboard, as
Note: As the appliance is supplied with a
thin film of grease, there might be a small
amount of smoke and odour the first time it is
used. This is not harmful and will stop after a
short time. Please
ventilation during this process.
1. Remove the individual parts from the
packaging.
2. Check that the individual parts are
complete (see "1.2 Scope of supply" on
page 3) and are undamaged.
3. Clean the appliance thoroughly before
using it for
"9. Cleaning and storing" on page 13).
6.1 Adjusting settings, switching on and
off
Note: As soon as you turn the rotary
knobs 7 or 6, the background illumination
for the displays will switch on automatically.
The light for the displays switches off again
automatically after 5 minutes.
Warning! Only connect the
appliance to an earthed mains
socket, as
electric shock depends on this.
SEAD 1800 B1

5. Unpacking and setting up

ensure adequate
the first time (see

6. Operating the appliance

protection against
steam escapes upwards and might
damage the furniture.
• Do not place the appliance on a hot
cooking ring.
• The appliance and accessories may not
be put in a microwave oven.
4. Unwind the mains cable 8 from the
cable store over its entire length.
5. Place the appliance on a level, dry, non-
slip surface so that the appliance can
neither fall over nor slide off.
6. Insert the power supply plug in a
suitable earthed mains socket (see
"3. Technical data" on page 4).
7. Add around 5 l water to the container 3.
8. Allow the water to boil for around 20
min (see "6. Operating the appliance"
on page 7).
9. Pour the water away.
The appliance is now ready to use.
1. Insert the power supply plug in a
suitable earthed mains socket (see
"3. Technical data" on page 4).
2. Turn the rotary
temperature 6 to the temperature you
require.
– The temperature is increased in
increments of 1 °C;
– A signal sounds every 5 °C;
– The temperature selected is shown on
the display for
selection 10.
knob for the
temperature
7