Upconversion Function; Basic Operation - Teac AI-101DA Bedienungsanleitung

Upconversion function

You can use the upconversion function with digital input (USB, OPTICAL) .
Press the UPCONVERT button on the remote control to enable the upconversion function . The
UPCONVERT indicator will light when upconversion is enabled .
Input sampling frequencies and sampling frequencies after upconversion
Input sampling frequency
32 kHz
44 . 1 kHz
48 kHz
64 kHz
88 . 2 kHz
96 kHz
128 kHz
176 . 4 kHz
192 kHz

Basic operation

1
Turn the power knob to STANDBY/ON.
The indicator will light blue when the unit is turned
on .
2
Turn the INPUT SELECTOR knob to select the
input source.
The indicator lights for the selected source .
The playback source will change in the following
order .
USB Bluetooth
w
o The input indicators blink when the input signal
is a digital audio signal in a format other than
PCM .
If this is the case, check to see if the connected
digital audio output device has a "PCM" setting
for the digital output format . Refer to the opera-
tion manual for that device to make this setting .
o When using this unit with a Windows computer,
before setting this unit to USB and playing back
audio files on the computer, you must install the
dedicated driver on that computer (page 22) .
Sampling frequency after upconversion
64 kHz
88 . 2 kHz
96 kHz
128 kHz
176 . 4 kHz
192 kHz
128 kHz
176 . 4 kHz
192 kHz
OPT1 OPT2
w w w
LINE
Continued on the next page
17
e