Gastroback Design Elektro Messer Bedienungsanleitung Seite 26

Channel
Bring blades together ensuring tips remain together (see picture).
WARNING:
injury. The safety guards should be facing the outside and the blades are not get-
ting easily taken apart.
3.
Safety Guard
carefully. If blades do not move, blades are fixed to main body.
WARNING:
bling or dismantling the appliance. The motor could get started accidently swit-
ching the on button.
4. When the blades are fitted connect the power outlet. Make sure that the power
cord is well away from moving blades when you start operating the appliance.
5. Holding the knife with one hand, slide and press the switch under the handle to
activate the motor. Releasing the switch will automatically stop the motor.
WARNING:
and other utensils away from moving blades during operation to prevent personal
injury and/or damage to the knife.
Note:
Do not use the appliance in continuous operation for more than 7 minutes to avoid
overheating. If processing large quantities of food, regularly interrupt the operation
and unplug the appliance for at least 3 minutes, allow the motor to cool down.
If the motor slows down or can not reach its normal speed, then release the on but-
ton, and unplug the appliance from the wall power outlet. Check whether there is
any obstruction between the blades, and remove it. Act upon instructions ›Care and
Cleaning‹.
26
Interlock blades together before inserting into the appli-
ance. To assemble blades, grasp shaft ends below the
safety guards. Take the blade with the rivet in your left
hand. The rivet should be facing upright and the safety
guard downward. With the right hand you take the
other blade (safety guard facing upright). This blade has
a hole and a narrow channel.
Ensure that the blades are correctly connected to avoid personal
Handle
Always ensure that the power cord is unplugged before assem-
Avoid contact with the moving parts. Keep hands, hair, clothing
Hold assembled blades by the safety
guards and slice shafts gently into the bla-
de slot until clipped into position (see pic-
ture). Make sure blades inserted to main
body in position. Try to pull out blades