Specifications; General Safety Rules - Makita GA7020F Betriebsanleitung

ENGLISH
1. Shaft lock
2. Switch trigger
3. Lock lever
4. Wheel guard
5. Screw
6. Bearing box

SPECIFICATIONS

Model
Depressed center wheel diameter
Spindle thread
No load speed (min
Overall length
Net weight
Rated voltage
• Due to our continuing program of research and development, the specifications herein are subject to change without
notice.
• Note: Specifications may differ from country to country.
Symbols
The following show the symbols used for the tool. Be sure
that you understand their meaning before use.
............. Read instruction manual.
............. DOUBLE INSULATION
............. Wear safety glasses.
Only for EU countries
Do not dispose of electric equipment together with house-
hold waste material!
In observance of European Directive 2002/96/EC on
waste electrical and electronic equipment and its imple-
mentation in accordance with national law, electric equip-
ment that have reached the end of their life must be
collected separately and returned to an environmentally
compatible recycling facility.
Intended use
The tool is intended for grinding, sanding and cutting of
metal and stone materials without the use of water.
Power supply
The tool should be connected only to a power supply of
the same voltage as indicated on the nameplate, and can
only be operated on single-phase AC supply. They are
double-insulated in accordance with European Standard
and can, therefore, also be used from sockets without
earth wire.
4
Explanation of general view
7. Lock nut
8. Depressed center wheel
9. Super flange
10. Inner flange
11. Lock nut wrench
12. Exhaust vent
GA7020/GA7020F/GA7020S/
-1
)
END202-2
GA7020SF
180 mm
M14
8,500
473 mm
4.7 kg
For public low-voltage distribution systems of
between 220 V and 250 V.
Switching operations of electric apparatus cause voltage
fluctuations. The operation of this device under unfavor-
able mains conditions can have adverse effects to the
operation of other equipment. With a mains impedance
equal or less than 0.27 Ohms it can be presumed that
there will be no negative effects. The mains socket used
for this device must be protected with a fuse or protective
circuit breaker having slow tripping characteristics.

GENERAL SAFETY RULES

WARNING:
When using electric tools, basic safety precautions,
including the following, should always be followed to
reduce the risk of fire, electric shock and personal
injury. Read all these instructions before operating
this product and save these instructions.
For safe operations:
1. Keep work area clean.
Cluttered areas and benches invite injuries.
2. Consider work area environment.
Do not expose power tools to rain. Do not use power
tools in damp or wet locations. Keep work area well lit.
Do not use power tools where there is risk to cause
fire or explosion.
3. Guard against electric shock.
Avoid body contact with earthed or grounded surfaces
(e.g. pipes, radiators, ranges, refrigerators).
4. Keep children away.
Do not let visitors touch the tool or extension cord. All
visitors should be kept away from work area.
5. Store idle tools.
13. Inhalation vent
14. Commutator
15. Insulating tip
16. Carbon brush
17. Brush holder cap
18. Screwdriver
GA9020/GA9020F/GA9020S/
GA9020SF
230 mm
M14
6,600
473 mm
4.7 kg
/II
ENA001-2