Fitting The Wall Mounting Bracket; Use - Cleanmaxx SLX225C Gebrauchsanleitung

Fitting the Wall Mounting Bracket

CAUTION!
• Choose a suitable place for the wall mounting bracket which should be as
dry and close to a plug socket as possible.
• Make sure that you do not drill into or destroy any pipes or cables. Find
out where possible pipes or cables may run and avoid them.
1. Now hold the wall mounting bracket against the chosen location and mark
the drill holes using a pencil.
2. Then attach the wall mounting bracket to the wall using the associated
screws and dowels.
3. If the barrel connector is not already attached in the wall mounting bracket,
plug it into the holder which is provided for this purpose.

Use

CAUTION!
• Ensure that there are no larger, sharp objects on the surface which is to be
cleaned.
• Make sure that the MAX marking on the dust container is not exceeded
when liquids are sucked up.
• Always hold the device horizontally when liquids are sucked up. Make sure
that sucked-up liquids do not get into the motor unit.
• Empty and clean the dust container after each use (see the "Cleaning and
Storage" chapter).
• Do not use the device when it is connected to the charger.
1. Remove the charger from the device.
2. Insert one of the attachments into the suction opening on the front of the
collecting container.
3. Select an attachment. The attachments are inserted into the suction opening
on the front of the device:
Crevice nozzle:
Use the crevice nozzle to vacuum in folds in fabrics, corners, recesses or
other places which are hard to reach.
Brush attachment:
Place the brush attachment onto the crevice nozzle. The brush attachment
cannot be used without the crevice nozzle! Use the brush attachment
to remove dust from delicate objects such as picture frames, lamp shades,
keyboards, books etc.
19 EN